Brooks KM 77 File
A collection of digital data stored in a computer's memory bank or on a floppy disc.
Horn
1) The part of the speaker that emits midrange and higher range frequencies.
2) A speaker or speaker enclosure where sound waves are put into a narrow opening (by a speaker cone or driver) and the narrow opening flairs out to a larger opening.
Brooks Cinema NZ 60 Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Cable, 1/4 inch
An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords".
Brooks QS 70 Acoustic Echo Chamber
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to the speaker and the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console.
Feed
To send an audio or control signal to.
Crossover Frequency
1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.
Absorption
Short for the term Acoustical Absorption (quality of a surface or substance to take in, not reflect, a sound wave).
Horn
1) The part of the speaker that emits midrange and higher range frequencies.
2) A speaker or speaker enclosure where sound waves are put into a narrow opening (by a speaker cone or driver) and the narrow opening flairs out to a larger opening.
Brooks Cinema NZ 60 Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Cable, 1/4 inch
An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords".
Brooks QS 70 Acoustic Echo Chamber
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to the speaker and the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console.
Feed
To send an audio or control signal to.
Crossover Frequency
1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.
Absorption
Short for the term Acoustical Absorption (quality of a surface or substance to take in, not reflect, a sound wave).
Comments
Post a Comment