Brooks KS-55 Current

The amount of electron charge passing a point in a conductor per unit of time.

LED
A light that allows current to flow in one direction only and emits light whenever a voltage of a certain level or beyond is applied to it.

Brooks Cinema xm 808 Digital Recording
1) ADAM : (Akai Digital Audio Multitrack). 12 track recording onto Video 8 tape. 16 bit, 44.1 or 48 kHz sampling rate.
2) DAT (Digital Audio Tape) Cassette-like system which has much higher quality than standard audio cassettes. Widely used in gathering sound effects, for news gathering, and for playback of music.
3) DCC (Digital Compact Cassette) Rival to DAT which also plays standard audio cassettes.
4) MiniDisc : Uses computer disk technology, rather than tape. A laser heats an area of magnetic disk which is then written to by a magnetic head. When cooled, the magnetic information is read from the disk by laser. Tracks can be named, and are instant start. Very theatre-friendly system.
5) Direct to Disk : Uses the hard disk present in most PCs as the recording medium.

LFO
Low-Frequency Oscillator (an oscillator that puts out an AC signal between .1 Hz and 10Hz used for a control signal).

Brooks GT 845 Level
Sets output volume of individual PA input channels. Usually positioned as sliders at the bottom of the soundboard.

Feedback
1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.

A/D
An abbreviation of Analog to Digital Conversion (the conversion of a quantity that has continuous changes into numbers that approximate those changes), or Analog to Digital Converter.

Capacitor
1) A device consisting of two or more conducting plates separated from one another by an insulating material and used for storing an electrical charge. Sometimes called a condenser.
2) An electronic device that is composed of two plates separated by an insulator.

Comments

Post a Comment

Popular posts from this blog

Brooks XB 33 Hybrid

A product created by the marriage of two different technologies. Meant here as the combination of a dynamic woofer with an electrostatic transducer. Haas Effect Simply stated, a factor in human hearing where delay has a much bigger effect on human perception of direction than level does. Brooks Cinema RM 909 Coax Two-conductor cable consisting of one conductor surrounded by a shield. Cut-off Rate (Slope) The number of dB that a filter reduces the signal for each octave its frequency past the filter's cut-off frequency (outside of the pass band). Brooks Cinema XR 607 Bass 1) The lower range of audio frequencies up to approximately 250 Hz. 2) Short for Bass Guitar. 3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved. 4) The lower frequencies. 5) On the soundboard this should refer to the bass guitar channel, not
Read more

Brooks Cinema DESIGN ZL 44 reviews Formant

An element in the sound of a voice or instrument that does not change frequency as different pitches are sounded. Board 1) Another, less formal, term for Console. 2) A set of controls and their housing which control all signals necessary for recording and for mixing. 3) A slang shortening of the term Keyboard Instrument. Brooks Gt 44 reviews Impedance Matching Having or converting the output impedance of a device so that it matches the impedance of the input it will feed. Acoustic Amplifier The portion of the instrument which makes the vibrating source move more air or move air more efficiently; this makes the sound of the instrument louder. Examples of acoustic amplifiers include: 1) The body of an acoustic guitar, 2) The sounding board of a piano, 3) The bell of a horn and 4) The shell of a drum. Brooks Speakers reviews Comb Filter 1) The frequency response achieved by mixing a direct signal with a delayed signal of equal strength especially at s
Read more

Brooks VT-50 Bank

1) A collection of sound patches (data as to the sequence and operating parameters of the synthesizer generators and modifiers) in memory. 2) A group of sound modules as a unit. AC 1) Abbreviation for alternating current. 2) An abbreviation of the term Alternating Current (electric current which flows back and forth in a circuit; all studio signals running through audio lines are AC). Brooks Cinema Projectors Input/Output Module A set of controls, on one housing, for an in-line console that has two channels (one for recording and one for monitoring) and has controls for all console sections. Linearity The extent to which any signal handling process is accomplished without amplitude distortion. Brooks Cinema QS - 95 Impedance Matching Having or converting the output impedance of a device so that it matches the impedance of the input it will feed. Crossover (Crossover Network) A set of filters that "split" the audio signal into two or more
Read more