Brooks GS 15 Layering
The recording (or playing) of a musical part with of several similar sound patches playing simultaneous.
Axis
A line around which a device operates. Example: In a microphone, this would be an imaginary line coming out from the front of the microphone in the direction of motion of the diaphragm.
Brooks M 44 Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.
High Impedance Mic
A microphone designed to be fed into an amplifier with input impedance greater than 20 k ohms.
Brooks VT-50 Capacitance
That property of a capacitor which determines how much charge can be stored in it for a given potential difference between its terminals, measured in farads, by the ratio of the charge stored to the potential difference.
Cut
1) One selection (one song) on a pre4ecorded music format.
2) A term with the same meaning as Mute (to turn off a channel or a signal).
3) To reduce gain of a particular band of frequencies (with an equalizer).
4) To not pass a particular band of frequencies (said of a filter)
Buss (Bus)
A wire carrying signals to some place, usually fed from several sources.
Keying Input (Key Input)
An input on a dynamics processing device to control the device by an external audio signal.
Axis
A line around which a device operates. Example: In a microphone, this would be an imaginary line coming out from the front of the microphone in the direction of motion of the diaphragm.
Brooks M 44 Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.
High Impedance Mic
A microphone designed to be fed into an amplifier with input impedance greater than 20 k ohms.
Brooks VT-50 Capacitance
That property of a capacitor which determines how much charge can be stored in it for a given potential difference between its terminals, measured in farads, by the ratio of the charge stored to the potential difference.
Cut
1) One selection (one song) on a pre4ecorded music format.
2) A term with the same meaning as Mute (to turn off a channel or a signal).
3) To reduce gain of a particular band of frequencies (with an equalizer).
4) To not pass a particular band of frequencies (said of a filter)
Buss (Bus)
A wire carrying signals to some place, usually fed from several sources.
Keying Input (Key Input)
An input on a dynamics processing device to control the device by an external audio signal.
Comments
Post a Comment