Brooks Cinema XB 33 Feed
To send an audio or control signal to.
High-Pass Filter
A device that rejects signals that are below a certain frequency (called the cut-off frequency) and passes signals with frequencies that are higher.
Brooks TA 60 Balance
1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.
Crossover Frequency
1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.
Brooks GT 44 Active/Inactive Microphones
Scientific definitions aside, active microphones generally sound better than inactive ones, but they generally cost more. They also require the use of either a battery or phantom power while inactive mics need only be plugged into the mic cord in order to work. In most playing situations, the subtle improvement in sound quality from an active mic isn't worth the extra cost and hassle. One possible exception it the headset mic. Put simply, inactive headset mics just plain suck. Active headset mics put out a much stronger signal and feed back much less.
Action
In guitar playing, action refers to how far the strings sit off of the guitar neck. When strings are close to the neck, it is referred to as "Low Action". When the string sit far above the neck, it is called "High Action". Guitars with low action are easier to play, but make sure they are not too close, or it could causing buzzing.
Flange
An effect caused by an approximately even mix of a modulated (varying) short delay with the direct signal.
Instrument Out Direct
Feeding the output of an electric instrument (like an electric guitar) to the recording console or tape recorder without using a microphone.
High-Pass Filter
A device that rejects signals that are below a certain frequency (called the cut-off frequency) and passes signals with frequencies that are higher.
Brooks TA 60 Balance
1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.
Crossover Frequency
1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.
Brooks GT 44 Active/Inactive Microphones
Scientific definitions aside, active microphones generally sound better than inactive ones, but they generally cost more. They also require the use of either a battery or phantom power while inactive mics need only be plugged into the mic cord in order to work. In most playing situations, the subtle improvement in sound quality from an active mic isn't worth the extra cost and hassle. One possible exception it the headset mic. Put simply, inactive headset mics just plain suck. Active headset mics put out a much stronger signal and feed back much less.
Action
In guitar playing, action refers to how far the strings sit off of the guitar neck. When strings are close to the neck, it is referred to as "Low Action". When the string sit far above the neck, it is called "High Action". Guitars with low action are easier to play, but make sure they are not too close, or it could causing buzzing.
Flange
An effect caused by an approximately even mix of a modulated (varying) short delay with the direct signal.
Instrument Out Direct
Feeding the output of an electric instrument (like an electric guitar) to the recording console or tape recorder without using a microphone.
Comments
Post a Comment