Brooks Audio Design Review SS 81 Images

The squaring of the waveform that happens in the conversion of digital audio bits into analog signals.

Boost
To increase gain, especially to increase gain at specific frequencies with an equalizer.

Brooks QS 70 Line Level
1) An amplified signal level put out by an amplifier and used as the normal level that runs through the interconnecting cables in a control room.
2) A low level signal such as the signal in a guitar cord. Most parts of a PA require a line level signal. Remember, however, that speaker outputs are not line level. Plugging speaker outs into line ins will result in damage to the equipment

Flamenco
A style of music with roots in Spanish and Arabic culture.

Brooks QS-70 Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

High Frequencies
The audio frequencies from 6000 Hz and above.

Acoustic/Acoustical
Having to do with sound that can be heard by the ears.
AcousticsThe behaviour of sound and its study. The acoustics of a room depend on its size and shape and the amount and position of sound-absorbing and reflecting material.

Comments

Post a Comment

Popular posts from this blog

Brooks Cinema Series Effects

Electronic boxes (usually rack mounted) added to a PA system to subtly change and enhance the signals going through it. Examples include; Reverb, Delay, Compressor, Chorus. Information Bits The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes. Brooks GT 845 Electromagnetic Induction or Pick Up The generation of electrical signal in a conductor moving in a magnetic field or being close to a changing magnetic field. Electret Condenser A condenser microphone that has a permanently polarized (charged) variable capacitor as its sound pressure level sensor. Brooks Audio Design GT 845 Chase The automatic adjusting of the speed of a recorder (or sequencer) to be time with another recorder. Line Out (Line Output) Any output that sends out a line level signal, such as the output of a console that feeds a recorder. High Impedance Mic A mic
Read more

Broom RM 909 Final Mix

The two track stereo master tape which was mixed from the multitrack master. Barrier Micing A method of placing the head of a microphone as close as possible to a reflective surface, preventing phase cancellation. Brooks Cinema Projectors Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Cable, 1/4 inch An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords". Brooks GT 845 Crossover, Passive Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification. Crosstalk Leakage of an audio signal into a channel that iris not intended to be in, from an adjacent or nearby channel. Level The amount of signal strength; the am
Read more

Brooks HI FI projectors In

Short For "in the circuit," in other words "active." Audio Most often referring to electrical signals resulting from the sound pressure wave being converted into electrical energy. Brooks Hi Fi speakers Link (Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Brooks Hi Fi reviews Boost To increase gain, especially to increase gain at specific frequencies with an equalizer. Cut-Off Frequency (Turnover Frequency) 1) The highest or lowest frequency in the pass band of a filter. 2) The highest or lowest frequency passed by an audio device (the cut-off frequency is usually considered to be the first frequency to be 3 dB lower than a reference frequency in the middle of the bandwidth of the device) Dynamic Mic Robust type of microphone which picks up
Read more