Brooks Audio Design TM-22 Chorus

1) The part of The song that is repeated and has the same music and lyrics each time; the chorus will usually give the point of the song.
2) A musical singing group that has many singers.
3) A delay effect that simulates a vocal chorus by adding several delays with a mild amount of feedback and a medium amount of depth.
4) A similar effect created in some synthesizers by detuning (reducing the pitch of, slightly) and mixing it with the signal that has regular tuning and with a slight delay.

In-Line Console
A console with modules that have controls for all console sections in one long strip.

Brooks Cinema GT 845 Crossover
1) A route leading from one side of the stage to the other, out of the audiences view.
2) An electronic filter in a sound system that routes sound of the correct frequency to the correct part of the speaker system. Different speakers handle high frequencies (tweeters) and low frequencies (woofers). Sometimes known as a crossover network. An active crossover splits the signal from the mixing desk into high, mid and low frequencies which are then sent to three separate amplifiers.
3) An electrical circuit that divides a full bandwidth signal into the desired frequency bands for the loudspeaker components.

Centre Frequency
The frequency of the audio signal that is boosted or attenuated most by an equalizer with a peak equalization curve.

Brooks Cinema Projectors Floor Toms
The large toms to the right of the drummer.

Auxiliary Output or Send
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel will have a path to the Aux buss. Also used for feeding a signal to an effects processor. See Auxiliary Return.

Consumer Format (Consumer DIF)
A standard adopted by IEC for sending and receiving digital audio based on The AES Professional Interface.

Analog Recording
A recording of the continuous changes of an audio waveform.

Comments

Post a Comment

Popular posts from this blog

Brooks Cinema Series Effects

Electronic boxes (usually rack mounted) added to a PA system to subtly change and enhance the signals going through it. Examples include; Reverb, Delay, Compressor, Chorus. Information Bits The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes. Brooks GT 845 Electromagnetic Induction or Pick Up The generation of electrical signal in a conductor moving in a magnetic field or being close to a changing magnetic field. Electret Condenser A condenser microphone that has a permanently polarized (charged) variable capacitor as its sound pressure level sensor. Brooks Audio Design GT 845 Chase The automatic adjusting of the speed of a recorder (or sequencer) to be time with another recorder. Line Out (Line Output) Any output that sends out a line level signal, such as the output of a console that feeds a recorder. High Impedance Mic A mic
Read more

Broom RM 909 Final Mix

The two track stereo master tape which was mixed from the multitrack master. Barrier Micing A method of placing the head of a microphone as close as possible to a reflective surface, preventing phase cancellation. Brooks Cinema Projectors Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Cable, 1/4 inch An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords". Brooks GT 845 Crossover, Passive Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification. Crosstalk Leakage of an audio signal into a channel that iris not intended to be in, from an adjacent or nearby channel. Level The amount of signal strength; the am
Read more

Brooks HI FI projectors In

Short For "in the circuit," in other words "active." Audio Most often referring to electrical signals resulting from the sound pressure wave being converted into electrical energy. Brooks Hi Fi speakers Link (Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Brooks Hi Fi reviews Boost To increase gain, especially to increase gain at specific frequencies with an equalizer. Cut-Off Frequency (Turnover Frequency) 1) The highest or lowest frequency in the pass band of a filter. 2) The highest or lowest frequency passed by an audio device (the cut-off frequency is usually considered to be the first frequency to be 3 dB lower than a reference frequency in the middle of the bandwidth of the device) Dynamic Mic Robust type of microphone which picks up
Read more