BROOKS AUDIO reviews Bar
A term meaning the same thing as the term Measure (the grouping of a number of beats in music, most-often four beats).
Input Impedance
The opposition to current flow by the first circuits of a device.
Brooks QS - 95 Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Format
1) The number of tracks, their width, spacing and order for tape recording.
2) To prepare a digital storage medium so that it will accept and store digital information bits.
Brooks GT 845 Diaphragm
A thin flexible membrane or cone that vibrates in response to electrical signals to produce sound waves. Distortion is usually referred to in terms of total harmonic distortion (THD) which is the percentage of unwanted harmonics of the drive signal present with the wanted signal. Generally used to mean any unwanted change introduced by the device under question.
Integrated Circuit (IC)
A miniature circuit of many components in a small, sealed housing with prongs to connect it into equipment.
Input/Output Module
A set of controls, on one housing, for an in-line console that has two channels (one for recording and one for monitoring) and has controls for all console sections.
Lift
1) To boost gain of audio at a particular band of frequencies with an equalizer.
2) An elevation device in the star trek series of TV programs.
Input Impedance
The opposition to current flow by the first circuits of a device.
Brooks QS - 95 Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Format
1) The number of tracks, their width, spacing and order for tape recording.
2) To prepare a digital storage medium so that it will accept and store digital information bits.
Brooks GT 845 Diaphragm
A thin flexible membrane or cone that vibrates in response to electrical signals to produce sound waves. Distortion is usually referred to in terms of total harmonic distortion (THD) which is the percentage of unwanted harmonics of the drive signal present with the wanted signal. Generally used to mean any unwanted change introduced by the device under question.
Integrated Circuit (IC)
A miniature circuit of many components in a small, sealed housing with prongs to connect it into equipment.
Input/Output Module
A set of controls, on one housing, for an in-line console that has two channels (one for recording and one for monitoring) and has controls for all console sections.
Lift
1) To boost gain of audio at a particular band of frequencies with an equalizer.
2) An elevation device in the star trek series of TV programs.
Comments
Post a Comment