Brooks KM 22 Compander

1) A two section device that is used in noise reduction systems. The first section compresses the audio signal, before it is recorded, and the second section, expands the signal after recording.
2) In Yamaha brand digital consoles, a signal processing function that applies both compression and expansion to the same signal.

Insert
1) A punch in of the all of the tracks being recorded in a recording session.
2) On Solid State Logic consoles, placing an outboard piece of gear in the channel by patching and activating a switch.

Brooks GT 845 Digital Recording
1) ADAM : (Akai Digital Audio Multitrack). 12 track recording onto Video 8 tape. 16 bit, 44.1 or 48 kHz sampling rate.
2) DAT (Digital Audio Tape) Cassette-like system which has much higher quality than standard audio cassettes. Widely used in gathering sound effects, for news gathering, and for playback of music.
3) DCC (Digital Compact Cassette) Rival to DAT which also plays standard audio cassettes.
4) MiniDisc : Uses computer disk technology, rather than tape. A laser heats an area of magnetic disk which is then written to by a magnetic head. When cooled, the magnetic information is read from the disk by laser. Tracks can be named, and are instant start. Very theatre-friendly system.
5) Direct to Disk : Uses the hard disk present in most PCs as the recording medium.

ADSR
The letters A, D, S &R are the first letters of: Attack, Decay, Sustain and Release. These are the various elements of volume changes in the sounding of a keyboard instrument.

Brooks Gt 44 Electric Instrument
Any musical instrument that puts out an electrical signal rather than an acoustic sound.

Decibel (dB)
1) Relative measurement for the volume (loudness) of sound. Also used to measure the difference between two voltages, or two currents. See Zero dB.
2) A numerical expression of the relative loudness of a sound. The difference in decibels between two
sounds is ten times the common logarithm of the ratio of their power levels.

Corner Frequency
Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN)

Haas Effect
Simply stated, a factor in human hearing where delay has a much bigger effect on human perception of direction than level does.

Comments

Post a Comment

Popular posts from this blog

Brooks XB 33 Hybrid

A product created by the marriage of two different technologies. Meant here as the combination of a dynamic woofer with an electrostatic transducer. Haas Effect Simply stated, a factor in human hearing where delay has a much bigger effect on human perception of direction than level does. Brooks Cinema RM 909 Coax Two-conductor cable consisting of one conductor surrounded by a shield. Cut-off Rate (Slope) The number of dB that a filter reduces the signal for each octave its frequency past the filter's cut-off frequency (outside of the pass band). Brooks Cinema XR 607 Bass 1) The lower range of audio frequencies up to approximately 250 Hz. 2) Short for Bass Guitar. 3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved. 4) The lower frequencies. 5) On the soundboard this should refer to the bass guitar channel, not
Read more

Brooks Cinema DESIGN ZL 44 reviews Formant

An element in the sound of a voice or instrument that does not change frequency as different pitches are sounded. Board 1) Another, less formal, term for Console. 2) A set of controls and their housing which control all signals necessary for recording and for mixing. 3) A slang shortening of the term Keyboard Instrument. Brooks Gt 44 reviews Impedance Matching Having or converting the output impedance of a device so that it matches the impedance of the input it will feed. Acoustic Amplifier The portion of the instrument which makes the vibrating source move more air or move air more efficiently; this makes the sound of the instrument louder. Examples of acoustic amplifiers include: 1) The body of an acoustic guitar, 2) The sounding board of a piano, 3) The bell of a horn and 4) The shell of a drum. Brooks Speakers reviews Comb Filter 1) The frequency response achieved by mixing a direct signal with a delayed signal of equal strength especially at s
Read more

Brooks VT-50 Bank

1) A collection of sound patches (data as to the sequence and operating parameters of the synthesizer generators and modifiers) in memory. 2) A group of sound modules as a unit. AC 1) Abbreviation for alternating current. 2) An abbreviation of the term Alternating Current (electric current which flows back and forth in a circuit; all studio signals running through audio lines are AC). Brooks Cinema Projectors Input/Output Module A set of controls, on one housing, for an in-line console that has two channels (one for recording and one for monitoring) and has controls for all console sections. Linearity The extent to which any signal handling process is accomplished without amplitude distortion. Brooks Cinema QS - 95 Impedance Matching Having or converting the output impedance of a device so that it matches the impedance of the input it will feed. Crossover (Crossover Network) A set of filters that "split" the audio signal into two or more
Read more