Brooks RM 909 Digital Recording

1) ADAM : (Akai Digital Audio Multitrack). 12 track recording onto Video 8 tape. 16 bit, 44.1 or 48 kHz sampling rate.
2) DAT (Digital Audio Tape) Cassette-like system which has much higher quality than standard audio cassettes. Widely used in gathering sound effects, for news gathering, and for playback of music.
3) DCC (Digital Compact Cassette) Rival to DAT which also plays standard audio cassettes.
4) MiniDisc : Uses computer disk technology, rather than tape. A laser heats an area of magnetic disk which is then written to by a magnetic head. When cooled, the magnetic information is read from the disk by laser. Tracks can be named, and are instant start. Very theatre-friendly system.
5) Direct to Disk : Uses the hard disk present in most PCs as the recording medium.

Condenser Microphone
A microphone which converts sound pressure changes into changes of capacitance. The capacitance changes are then converted into electrical voltage variations (an audio signal).

Brooks Hi Fi reviews Cable, XLR
A balanced cable used for low impedance microphones and sometimes for connections between some parts of the PA. Commonly referred to as a "mic cord".

Golden Section
A ratio of height to width to length of a room to achieve "good acoustics" and first recommended by the ancient Greeks. The ratio is approximately the width 1.6 times the height and the length 2.6 times the height

Brooks RM 909 reviews Ground
In electronics, a place (terminal) that has zero volts.

Equalizer (Parametric, Graphic)
This is used to filter out and adjust specific frequencies in the PA. This is the part of the PA where you have the most control over the band's overall sound. It is also the number one weapon against feedback.

Foot Pedal
1) An effects device where the amount of the effect can be controlled by a musician with his foot.
2) The beater mechanism of a foot drum that is activated by the drummer's foot to play the drum.
3) Any device, like a volume control, that can be operated by the foot.

Edit
A switch that does different things depending on the operational mode that the machine is in:
1) If a computer-controlled transport is in "Stop," pushing the "Edit" switch deactivates the computer-controlled tension system and allows the reels to be moved by hand to find the exact spot desired on the tape.
2) If the machine is in "Play", the "Edit" switch makes the take-up reel cease taking up the tape and it falls to the floor.
3) If the machine is in a fast-wind mode, the tape lifters are defeated so the tape is in contact with the reproduce head and the engineer can hear where the selections begin and end.

Comments

Post a Comment

Popular posts from this blog

Broom RM 909 Final Mix

The two track stereo master tape which was mixed from the multitrack master. Barrier Micing A method of placing the head of a microphone as close as possible to a reflective surface, preventing phase cancellation. Brooks Cinema Projectors Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Cable, 1/4 inch An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords". Brooks GT 845 Crossover, Passive Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification. Crosstalk Leakage of an audio signal into a channel that iris not intended to be in, from an adjacent or nearby channel. Level The amount of signal strength; the am...
Read more

Brooks Cinema Series Effects

Electronic boxes (usually rack mounted) added to a PA system to subtly change and enhance the signals going through it. Examples include; Reverb, Delay, Compressor, Chorus. Information Bits The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes. Brooks GT 845 Electromagnetic Induction or Pick Up The generation of electrical signal in a conductor moving in a magnetic field or being close to a changing magnetic field. Electret Condenser A condenser microphone that has a permanently polarized (charged) variable capacitor as its sound pressure level sensor. Brooks Audio Design GT 845 Chase The automatic adjusting of the speed of a recorder (or sequencer) to be time with another recorder. Line Out (Line Output) Any output that sends out a line level signal, such as the output of a console that feeds a recorder. High Impedance Mic A mic...
Read more

Broom RM 909 Face

The front or body of the guitar. BPM An abbreviation of Beat Per Minute (the number of steady even pulses in music occurring in one minute and therefore defining the tempo). Brooks Cinema XS - 45 Inductance The property of an electric circuit by which a varying current in it produces a varying magnetic field that introduces voltages in the same circuit or in a nearby circuit. It is measured in henrys. Lead The musical instrument that plays the melody of the tune, including the vocal. Brooks Cinema XB 33 Controller 1) In MIDI, a device that generates a MIDI signal to control synthesizers, sound modules or sample playback units. 2) A remote control unit for a multitrack tape machine which controls transport functions as well as monitor selection switching functions and record ready/safe status of each track. 3) Any device generating a control voltage or signal fed to another device's control input. Librarian Program A computer program allowing the ...
Read more