Brooks RM 909 reviews Analog (Analogue)

Representative, continuous changes that relate to another quantity that has a continuous change.

Echo Chamber
1) A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone.
2) Any artificial or electronic device that simulates the reverberation created in a room.

Brooks Hi Fi speakers High Impedance Mic
A microphone designed to be fed into an amplifier with input impedance greater than 20 k ohms.

Instrument Out Direct
Feeding the output of an electric instrument (like an electric guitar) to the recording console or tape recorder without using a microphone.

Brooks HI FI projectors Earth
The British version of the term Ground (In electronics, a place that has zero volts).

Frets
Vertical metal wires which sit vertically on the guitar neck.

Linearity
The extent to which any signal handling process is accomplished without amplitude distortion.

Aux Send
Short for the term Auxiliary Send (a control to adjust the level of the signal sent from the console input channel to the auxiliary equipment through the aux buss.

Comments

Post a Comment

Popular posts from this blog

Brooks Cinema Series Effects

Electronic boxes (usually rack mounted) added to a PA system to subtly change and enhance the signals going through it. Examples include; Reverb, Delay, Compressor, Chorus. Information Bits The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes. Brooks GT 845 Electromagnetic Induction or Pick Up The generation of electrical signal in a conductor moving in a magnetic field or being close to a changing magnetic field. Electret Condenser A condenser microphone that has a permanently polarized (charged) variable capacitor as its sound pressure level sensor. Brooks Audio Design GT 845 Chase The automatic adjusting of the speed of a recorder (or sequencer) to be time with another recorder. Line Out (Line Output) Any output that sends out a line level signal, such as the output of a console that feeds a recorder. High Impedance Mic A mic
Read more

Broom RM 909 Final Mix

The two track stereo master tape which was mixed from the multitrack master. Barrier Micing A method of placing the head of a microphone as close as possible to a reflective surface, preventing phase cancellation. Brooks Cinema Projectors Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Cable, 1/4 inch An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords". Brooks GT 845 Crossover, Passive Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification. Crosstalk Leakage of an audio signal into a channel that iris not intended to be in, from an adjacent or nearby channel. Level The amount of signal strength; the am
Read more

Brooks GS 15 Gate

A dynamic processing device that turns a channel off or down when the signal drops below a certain level. Link (Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o Brooks M 44 Filter 1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, used in this sense because filters are used with other components to give an equalizer its frequency response characteristics. 3) The action of removing signals of some frequencies and leaving the rest. 4) A mechanical device to smooth out speed variations in tape machines called a Scrape Flutter Filter- more usually called a Scrape Flutter Idler Cut-off Rate (Slope) The number of dB that a filter reduces the signal for each octave its frequency past the filter's cut-off frequency (outside of the pass band). Brooks TA 60 Effects Electronic boxes (usually rack mounted)
Read more