Brooks RM 909 reviews Compact Disc Recordable CDR

A blank Compact Disc that can be recorded on one time.

Electronics
1) On a tape machine, the housing for and the channel circuitry which processes the signal to be fed to the heads, provide bias, and playback.
2) The branch of science dealing with the behaviour of electrons/charges in vacuums, gases, semiconductors and special conductors.

Brooks RM 909 Band Track
1) A mixdown of a song without the lead vocal or without the lead and background vocals.
2) A term with the same meaning as the term Rhythm Track.
3) The recording of the rhythm instruments in a music production.

Fret Buzz
A buzzing sound made when a note is not properly fretted. Common with cheap guitars or beginning guitar players.

Brooks HI FI projectors Golden Section
A ratio of height to width to length of a room to achieve "good acoustics" and first recommended by the ancient Greeks. The ratio is approximately the width 1.6 times the height and the length 2.6 times the height

Fat
Having more than a normal amount of signal strength at low frequencies or having more sound than normal (by use of compression or delay).

Hz (Hertz)
1) An abbreviation for the term Hertz (the unit of frequency).
2) Unit of frequency equivalent to the number of cycles per second.

Fletcher Munson Effect
A hearing limitation shown by Fletcher Munson Equal Loudness Contours (as music is lowered in volume, it is much more difficult to hear bass frequencies and somewhat harder to hear very high frequencies).

Comments

Post a Comment

Popular posts from this blog

Brooks Cinema Series Effects

Electronic boxes (usually rack mounted) added to a PA system to subtly change and enhance the signals going through it. Examples include; Reverb, Delay, Compressor, Chorus. Information Bits The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes. Brooks GT 845 Electromagnetic Induction or Pick Up The generation of electrical signal in a conductor moving in a magnetic field or being close to a changing magnetic field. Electret Condenser A condenser microphone that has a permanently polarized (charged) variable capacitor as its sound pressure level sensor. Brooks Audio Design GT 845 Chase The automatic adjusting of the speed of a recorder (or sequencer) to be time with another recorder. Line Out (Line Output) Any output that sends out a line level signal, such as the output of a console that feeds a recorder. High Impedance Mic A mic
Read more

Broom RM 909 Final Mix

The two track stereo master tape which was mixed from the multitrack master. Barrier Micing A method of placing the head of a microphone as close as possible to a reflective surface, preventing phase cancellation. Brooks Cinema Projectors Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Cable, 1/4 inch An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords". Brooks GT 845 Crossover, Passive Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification. Crosstalk Leakage of an audio signal into a channel that iris not intended to be in, from an adjacent or nearby channel. Level The amount of signal strength; the am
Read more

Brooks GS 15 Gate

A dynamic processing device that turns a channel off or down when the signal drops below a certain level. Link (Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o Brooks M 44 Filter 1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency. 2) An equalizer section, used in this sense because filters are used with other components to give an equalizer its frequency response characteristics. 3) The action of removing signals of some frequencies and leaving the rest. 4) A mechanical device to smooth out speed variations in tape machines called a Scrape Flutter Filter- more usually called a Scrape Flutter Idler Cut-off Rate (Slope) The number of dB that a filter reduces the signal for each octave its frequency past the filter's cut-off frequency (outside of the pass band). Brooks TA 60 Effects Electronic boxes (usually rack mounted)
Read more