Brooks RM 909 Headphones

Devices that can be worn on the head with small speakers that fit over the ears (or sometimes into the ears).

Close Micing
A technique of placing a microphone close to the sound source (within one foot) in order to pick up mainly the direct sound and to avoid picking up leakage or ambience.

Brooks RM 909 reviews Linear
The condition of obtaining a change at the output of the device which is proportional to the change occurring at the input.

Foot (Foot Drum)
Another name for Bass Drum (the largest drum in the Drum Kit which puts out bass frequencies and is played with a foot pedal).

Brooks Hi Fi reviews Balance Control
A control on a stereo amplifier that when moved clockwise will make the right channel louder (and the left channel softer) and will do the reverse when moved counter-clockwise.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

Current
The amount of electron charge passing a point in a conductor per unit of time.

Bridge
The bridge assembly, or just "bridge" is an area on the face of the guitar where the string meet or are connected to the face.

Comments

Post a Comment

Popular posts from this blog

Broom RM 909 Final Mix

The two track stereo master tape which was mixed from the multitrack master. Barrier Micing A method of placing the head of a microphone as close as possible to a reflective surface, preventing phase cancellation. Brooks Cinema Projectors Corner Frequency Same as Cut-Off Frequency (the highest or lowest frequency in the pass band of a filter). (NOUN) Cable, 1/4 inch An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords". Brooks GT 845 Crossover, Passive Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification. Crosstalk Leakage of an audio signal into a channel that iris not intended to be in, from an adjacent or nearby channel. Level The amount of signal strength; the am...
Read more

Brooks RM 909 Link

(Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o Compact Disc CD A small optical disk with digital audio recorded on it. Brooks Hi Fi speakers Lift 1) To boost gain of audio at a particular band of frequencies with an equalizer. 2) An elevation device in the star trek series of TV programs. Frequency The number of cycles of a waveform occurring in a second. Brooks Hi Fi reviews Initialize To prepare a digital storage medium (like a floppy disk) so that it will accept and store digital information bits. Final Mix The two track stereo master tape which was mixed from the multitrack master. Electret Mic A condenser microphone where the capacitor plates are given a charge during manufacture which they retain, therefore requiring no external power supply. Ambience The portion of the sound that comes from the surrounding environment rather than directly from the sound sour...
Read more

Brooks RM 909 Current

The amount of electron charge passing a point in a conductor per unit of time. Frequency Shift Key / FSK The full name for FSK (A simple clock signal that can be used to run a sequencer in time with an audio tape). Brooks HI FI projectors Cut 1) One selection (one song) on a pre4ecorded music format. 2) A term with the same meaning as Mute (to turn off a channel or a signal). 3) To reduce gain of a particular band of frequencies (with an equalizer). 4) To not pass a particular band of frequencies (said of a filter) Amplifier Sound equipment that converts the low voltage, low current signal from a tape deck, mixer etc. into a higher current signal suitable for driving speakers. See Power Amplifier, Crossover. Brooks Hi Fi reviews Dynamic Mic Robust type of microphone which picks up the sound on a diaphragm connected to a coil of wire which moves within a magnet. An alternating current is induced into the wire which provides the electrical output. Most dyn...
Read more