Brooks Hi Fi reviews Equalizer (Parametric, Graphic)
This is used to filter out and adjust specific frequencies in the PA. This is the part of the PA where you have the most control over the band's overall sound. It is also the number one weapon against feedback.
Channel
1) In multitrack tape machines, this term means the same thing as the term Track (one audio recording made on a portion of the width of a multitrack tape).
2) A single path that an audio signal travels or can travel through a device from an input to an output.
Brooks HI FI projectors Golden Section
A ratio of height to width to length of a room to achieve "good acoustics" and first recommended by the ancient Greeks. The ratio is approximately the width 1.6 times the height and the length 2.6 times the height
Line
1) Short for line level.
2) A cable.
Brooks Hi Fi speakers Level
Sets output volume of individual PA input channels. Usually positioned as sliders at the bottom of the soundboard.
Line Level
1) An amplified signal level put out by an amplifier and used as the normal level that runs through the interconnecting cables in a control room.
2) A low level signal such as the signal in a guitar cord. Most parts of a PA require a line level signal. Remember, however, that speaker outputs are not line level. Plugging speaker outs into line ins will result in damage to the equipment
Feedback
1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.
Keying Input (Key Input)
An input on a dynamics processing device to control the device by an external audio signal.
Channel
1) In multitrack tape machines, this term means the same thing as the term Track (one audio recording made on a portion of the width of a multitrack tape).
2) A single path that an audio signal travels or can travel through a device from an input to an output.
Brooks HI FI projectors Golden Section
A ratio of height to width to length of a room to achieve "good acoustics" and first recommended by the ancient Greeks. The ratio is approximately the width 1.6 times the height and the length 2.6 times the height
Line
1) Short for line level.
2) A cable.
Brooks Hi Fi speakers Level
Sets output volume of individual PA input channels. Usually positioned as sliders at the bottom of the soundboard.
Line Level
1) An amplified signal level put out by an amplifier and used as the normal level that runs through the interconnecting cables in a control room.
2) A low level signal such as the signal in a guitar cord. Most parts of a PA require a line level signal. Remember, however, that speaker outputs are not line level. Plugging speaker outs into line ins will result in damage to the equipment
Feedback
1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.
Keying Input (Key Input)
An input on a dynamics processing device to control the device by an external audio signal.
Comments
Post a Comment